Different options are equipped with different black fixing plates to adapt to various versions of rc excavators. Operating Voltage: 7V9V (2S, not compatible with 3S lithium battery).
Manufacturing Process: CNC ultra-precision machining. Saw Blade Outer Diameter: 50mm.
Compatibility: Double E EC160 E010 E111, Kabolite K336GC K961, HUINA 1580 1594 1599 Hydraulic Upgraded Excavators. Install the chainsaw onto the quick-change connector of the excavator, ensuring a secure connection, and insert the three black extension cables into the connector (no need to distinguish between wire sequence). Connect the other end of the extension cables to the control board, and connect the 3-pin signal wire on the board to any channel on the receiver. Map one channel on the remote control for chainsaw operation (such as a joystick or potentiometer knob), making sure the channel corresponds to the signal wire connected to the control board. Connect the 2S lithium battery to the power interface on the control board. Use the remote control to operate the chainsaw, with control over functions such as on/off and speed controlled through the corresponding channel. Due to the narrow clearance between the upper and lower parts of the black fixing plate on the chainsaw, it may not be able to be directly installed on the excavator's arm. Continuous long-term operation is not recommended. If the motor overheats, stop immediately and wait for it to cool down before working again. Do not use a 3S lithium battery. As this may directly damage the motor. 3 x Black extension cables.